Posts and tensioning: the structure behind a chain link fence
Chain link mesh has no strength of its own. Whether a fence stays tight or sags depends on the posts, their footings, the braces and the straining wires – the part most people never look at.
Posts and tensioning are the structural system of a chain link fence: posts set in concrete footings, diagonal braces at ends and corners, and straining wires pulled tight with tensioners, to which the mesh is tied.
Why do posts and tension decide the fence?
In short: the mesh hangs on the structure – if posts lean or wires slacken, the whole fence sags.
Woven mesh behaves like fabric. Pull it between two fixed points and it stays flat; let one point move and it folds. In a chain link fence, those fixed points are the end and corner posts, and what keeps the fabric flat along its length are the straining wires.
Tired fences usually fail here: corner posts without braces leaning inward, posts driven into soil with no footing, or straining wires missing altogether. That is why we treat this part of the job as the core of the fence, whatever mesh you choose. See straining wire explained for more on the wires themselves.

What kinds of posts does a chain link fence need?
In short: braced end and corner posts that carry the tension, and lighter intermediate posts that hold the line.
Not all posts do the same job:
- End posts sit where the fence starts or stops. They take the full pull of the wires and mesh, so they are braced.
- Corner posts take tension from two directions and are braced on both sides.
- Change-of-direction posts appear where the line bends or the slope changes sharply; they need bracing too.
- Intermediate posts stand along the straights. They keep the line straight and the mesh at height but do not carry the main tension.
On long straights, an extra braced post part-way along breaks the run into manageable sections. The number of braced posts is one of the clearest differences between a careful quote and a cheap one.
Why do posts need concrete footings?
In short: footings keep posts upright under tension, wind and animal pressure; posts simply driven into soil tend to lean.
We set posts in concrete. The size and depth of each footing depend on the post's role, the soil and the fence height; braced posts get more attention than intermediate ones. In rocky ground we adapt the footing to what the rock allows rather than forcing a standard shape.
Footings also matter for water. A post sitting in a puddle of loose soil will move after every heavy rain. Where water runs along the line, we look at how to keep it from undermining the footings. On slopes, see our guide to chain link on slopes.

How is the mesh tensioned?
In short: the straining wires are tensioned between braced posts, then the mesh is pulled taut and tied to them.
Once the footings have set, we run straining wires along the line between braced posts and tighten them with wire tensioners. The mesh is then fixed at one braced post, pulled taut along the section and fixed at the next, and tied to the straining wires and intermediate posts at regular intervals.
Tension needs judgment: too little and the mesh waves; too much and it distorts or pulls posts out of line. Tensioners make it possible to adjust the wires later, which is part of normal chain link maintenance.

Can new mesh go on existing posts?
In short: only when the posts are sound, upright, set in proper footings and braced where they should be.
Owners sometimes ask us to rehang mesh on an existing line of posts. We look at each post: is it upright, is it solid at ground level, is there a footing, are the corners braced? If the answer is yes, re-meshing can be a sensible job. If not, new mesh will sag again within a short time, and we will say so. In that case see old fence removal and replacement.
How do posts and tension affect the price?
In short: more corners and changes of direction mean more braced posts and footings, which is a large share of the work.
A square plot has four corners; an irregular finca can have dozens of changes of direction. Each one adds a braced post, a footing and tensioning hardware. Rock adds digging time. These items are listed separately in our quotes, and the price site presupuestovalla.eu explains how they usually appear in fence quotes.
How we build it – step by step
- Planning the post layout
We mark ends, corners and changes of direction, then space the intermediate posts along the straights.
- Digging
We dig the holes, giving braced posts the attention their role requires and adapting to rock.
- Setting posts in concrete
We set and plumb each post in its footing, checking the line with a string.
- Fitting braces
We fit diagonal braces to end, corner and change-of-direction posts.
- Running straining wires
After the concrete has set, we run straining wires along each section and tighten them with tensioners.
- Tensioning the mesh
We fix the mesh at one braced post, pull it taut and fix it at the next.
- Tying off
We tie the mesh to the straining wires and intermediate posts and do a final check of tension and alignment.
When is it the right choice – and when not?
A good fit if…
- Every new chain link fence
- Re-meshing a line whose posts are still sound
- Long runs that need intermediate braced posts
- Irregular boundaries with many changes of direction
Consider another option if…
- Hanging new mesh on leaning or rotten posts
- Posts driven into soil without footings on a permanent fence
- Using a fence as a structural support for anything else
What affects the cost?
We don't publish fixed prices: every fence is quoted line by line using these factors.
- Number of braced posts (ends, corners, changes of direction)
- Number of intermediate posts
- Footing size and ground conditions
- Rock and hard digging
- Fence height
- Tensioning hardware
- Access for materials and concrete
- Removal of old posts
Articles and guides

Galvanised chain link fence for rural plots in Málaga
Plain galvanised chain link is the workhorse of rural boundaries in Málaga province. We build it on concrete footings with braced posts and straining wire, so it stays straight and tight.
View details →
Old fence removal and replacement with new chain link
When an old wire fence sags, leans or has fallen in sections, patching it rarely lasts. We take it out along the line and build a new chain link fence in its place, as one job.
View details →Straining wire explained: what keeps chain link tight
Straining wire is the least visible part of a chain link fence and the one that decides how it looks a few years later. This guide explains what it does, how it works with the posts, and what to ask a contractor.
View details →
What can go wrong while a chain link fence is being built?
Most chain link jobs go to plan. When they do not, it is usually for the same handful of reasons. Knowing them in advance makes the conversation easier if one comes up.
View details →Frequently asked questions
Why do corner posts need braces?
Because they carry the pull of the mesh and wires. Without a brace, a corner post slowly leans toward the fence and the mesh goes slack.
Are concrete footings really necessary?
For a permanent, tensioned fence, yes. Posts only driven into soil tend to lean under tension and after rain.
Can I retension my own fence?
That is a matter for you, but we do not give DIY instructions. If your fence has gone slack, we can assess whether retensioning or rebuilding is the right fix.
How many straining wires does a fence need?
It depends on height and use. We specify the number in the quote so you can compare offers.
Why does my fence sag in the middle?
Usually because a braced post has moved, a straining wire has snapped or slackened, or ties have failed. The cause decides the fix.
Steel or concrete posts?
For chain link we normally use steel posts suited to the mesh. Other post types are common for field fencing over large areas.
Can posts be fixed on rock?
Often yes, by adapting the footing to the rock. We decide on site.
Do intermediate posts need concrete?
On the fences we build, yes. It keeps the line straight and the mesh at height.
Can you re-mesh my existing posts?
If the posts are sound, upright and braced, yes. We check before quoting.
What is a change-of-direction post?
A post where the line bends or the slope changes sharply. It takes tension at an angle and is braced like a corner post.
Send photos of your boundary
Photos and an approximate length are enough to start. We measure, then send an itemised quote with no commitment – even if you are not in Spain.